Gas Blowtorch with Steel Burner KLL-7002D
|coonection type||bayonet connection|
|product material||iron+aluminum+zinc alloy +plastic|
|packaging||1 pc/blister card 10pcs/inner box 100pcs/ctn|
1.Push the gas cartridge into the base and turn counter-clockwise to secure.
2.Do not force the gas cartridge when installing .
3. Open the gas release knob counter-clockwise slightly to emit a smal amount of gas and light the CANON TORCH by match .
4.Adjust the flame intensity to your particular requirements . Turn gas release knob clockwsie to extinguish the flame . Always remove the gas cartridge after use .
Method of operation
-Turn the knob slowly in the right direction to start gas flowing then press the trridge in until it clicks.
-Repeat of unit fails to light
-The appliance is now ready for use.Adjust the flame between”-“ and “+”(low and high heat)position as required.
-Be aware of flaring which may occur during the two minute warm-up period and during which the applicane should not be angled more than 15 degrees from the vertical(upight)position.
To shut off
-Close gas supply off completely by turning gas control knob in the “clockwise”(“-”)direction.
-Separate the applicance from the gas cartridge after use.
-Check the applicance is clean and dry.
-Store in a cool,well ventilated place after separating the cartridge from the appliance and replacing cap.